QIWU iGPSPORT iGS10 User Manual page 6

4) Select left button to enter E1 mode when E1 is flashing.
5) iGS10 will search ANT+ sensors automatically.
5) When sensors are connected, the icons will light up.
6) iGS10 will exit searching sensors mode in 20 seconds.
Note：
1) iGS10 will automatically connect the sensors that have been connected.
2) It is required to search the sensor again after battery is replaced.
8. SETTING THE WHEEL SIZE & CIRCUMFERENCE (SETTING MODE E2)
Please set the wheel circumference if you use a speed sensor.
Default wheel circumference: 2096mm
Steps:
1) Hold right button more than 2 seconds to enter the setting mode.
right button
2) Select
Select left button to enter E2 mode when E2 is flashing.
3)
4) Select left button to change numerical digits, select
value.
5) Hold right button more than 2 seconds to save and exit.
to scroll setting mode from E1 to E4.
right button
to change numerical
6