Configuring The Network - Network Menu; Network Tab; Multicast Streaming - Sony Ipela SNC-RZ50N User Manual

here and an odd number with 1 added to the specified
number) are actually used for audio data communication
and control.
Note
Specify different numbers for the video port number and
the audio port number.

Multicast streaming

Set whether the camera uses multicast streaming for
MPEG4 video data and audio data or not. It reduces the
transmission load on the camera by making the
computer of the same segment network receive the same
transmitting data.
Select On to allow and Off not to allow multicast
sending.
When you select On, set Multicast address, Video port
number and Audio port number properly.
Multicast address
Type the multicast address used on the Multicast
streaming.
Video port number
Specify transmission port number of the MPEG4 video
data used for the Multicast streaming. It is initially set to
60000. Specify an even number from 1024 to 65534.
Two port numbers (the number specified here and an
odd number with 1 added to the specified number) are
actually used for video data communication and control.
Audio port number
Specify the audio transmission port number used for the
Multicast streaming. It is initially set to 60002. Specify
an even number from 1024 to 65534. Two port numbers
(the number specified here and an odd number with 1
added to the specified number) are actually used for
audio data communication and control.
Note
Specify different numbers for the video port number and
the audio port number.
OK/Cancel
See "Buttons common to every menu" on page 30.
Configuring the Network
— Network Menu
When you click Network in the Administrator menu,
the Network menu appears.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
Wireless and Dynamic IP address notification.

Network Tab

This section provides the menus for connecting the
camera through the network cable.
MAC address
Displays the MAC address of the camera.
IP address
Configure the IP address.
Obtain an IP address automatically (DHCP): Select
this option when a DHCP server is installed on the
network to allow IP address assignment. With this
setting, the IP address is assigned automatically.
Use the following IP address: Select this option when
you set a fixed IP address. With this setting, specify
the IP address, Subnet mask and Default gateway
manually.
Note
When you select Obtain an IP address automatically
(DHCP), make sure that a DHCP server is operating on
the network.
IP address
Type the IP address of the camera.
Subnet mask
Type the subnet mask.
Configuring the Network — Network Menu
41