The Ethernet Port - G&L MMC-A2 Hardware Manual

A typical MMC 10Base T connection is shown below.
Figure 6-3: Ethernet - TCP/IP 10Base T Connections
MMC
Maximum segment length is 100 M (328 ft).

6.2.1 The Ethernet Port

G & L Motion Control Inc.
ETHERNET
DIAG
GDLNK EO EI
2.
COL PREV
OUT IN
COM1
1.
OUT IN
COM2
Enable
Disable
REMOTE
PROGRAMMER
ACCESS
10 BaseT
COM1
COM2
Shielded 10Base T Twisted Pair
Hub
Node
Node
The 10Base-T port uses a RJ-45 style 8-pin connector using 100
ohm unshielded twisted pair category 3 or 5 cable (IEEE 802.3
section 14.4). The maximum length of the twisted pair cable
segment is 100 M (328 ft). NOTE: The connector is also suitable
for shielded cable and will ground the shield to the chassis.
Pin descriptions for are provided in
•
Pin assignments are provided in
•
The available Ethernet Port to Ethernet Device cables are
•
described in Table 6-4
MMC Hardware Manual
MMC Ethernet TCP/IP Option Mod-
Segment
Table 6-2
Table 6-3
ule
Node
119