Kenmore 253.6000 Series Use & Care Manual page 24

Care & Cleaning
Part What To Use
Interior & • Soap and water
Door Liners
• Baking soda
and water
Door Gaskets • Soap and water Wipe gaskets with a clean soft cloth.
Drawers & • Soap and
Bins water
Glass • Soap and water
Shelves
• Glass cleaner
• Mild liquid sprays
Toe Grille • Soap and water
• Mild liquid sprays
• Vacuum
attachment
Exterior & • Soap and water
Handles
• Non Abrasive
Glass Cleaner
Exterior & • Soap and water
Handles
• Stainless Steel
Cleaners
(Stainless
Steel Models
Only)
Replacing • Unplug
Light Bulbs refrigerator
• Wear gloves
• Remove light
cover (some
models)
• Replace old bulb
• Replace light
cover (some
models)
• Plug in the
refrigerator
Care & Cleaning Tips
Use 2 tablespoons of baking soda in 1 quart of
warm water. Be sure to wring excess water out of
sponge or cloth before cleaning around controls,
light bulb or any electrical part.
Use a soft cloth to clean drawer runners and tracks.
Allow glass to warm to room temperature before
immersing in warm water.
Vacuum dust from front of toe grille. Remove
toe grille (see Installation Instructions). Vacuum
backside, wipe with sudsy cloth or sponge. Rinse
and dry.
Do not use commercial household cleaners
containing ammonia, bleach or alcohol to clean
handles. Use a soft cloth to clean smooth handles.
DO NOT use a dry cloth to clean smooth doors.
Never use CHLORIDE or cleaners with bleach to
clean stainless steel.
Clean stainless steel front and handles with non-
abrasive soapy water and a dishcloth. Rinse with
clean water and a soft cloth. Use a non-abrasive
stainless steel cleaner. These cleaners can be
purchased at most home improvement or major
department stores. Always follow manufacturer's
instructions. Do not use household cleaners
containing ammonia or bleach.
NOTE: Always clean, wipe and dry with the grain
to prevent scratching. Wash the rest of the cabinet
with warm water and mild liquid detergent. Rinse
well, and wipe dry with a clean soft cloth.
CAUTION: Wear gloves when replacing light
bulbs to avoid getting cut. Use same wattage when
replacing bulb
24
Tips and Precautions