V202 Protokoll - Deviation Devo 6 User Manual

Freq-fine: Frequency offset adjustment. Range -127 to 127. Adjusts for variances betweeen CC2500
modules. Usually offset of 0 or -41 is required, but full range should be tested if there are problems with
binding or range. Default 0.

9.22 *V202 protokoll

The V202 protocol supports the WLToys V202 quadracopter. NOTE: This protocol requires the addition
of an 'NRF24L01' hardware module to function. See the following document for more information:
http://www.deviationtx.com/wiki/#hardware_modifications
The V202 protocol supports up to 12 channels, does not support auto-binding. If Fixed ID is set to None, a
transmitter-specific ID is used instead. It is necessary to manually bind each model before the first use.
The 1 st 4 channels represent Aileron, Elevator, Throttle, and Rudder. Additional channels control the
quadracopter special functions:
• Channel 5 controls the blink speed
• Channel 6 enables 'flip' mode
• Channel 7 takes still pictures
• Channel 8 turns video on/off
• Channel 9 turns headless mode on/off
• Channel 10 causes the x axis to calibrate
• Channel 11 causes the y axis to calibrate
If JXD-506 format is selected, channels 10-12 are used for:
• Channel 10 start/stop
• Channel 11 emergency stop
• Channel 12 gimbal control
Also, models compatible with this format require the throttle stick to be centered before arming.
9.23 *SLT protokoll
The SLT protocol is used to control TacticSLT/Anylink receivers. NOTE: This protocol requires the
addition of an 'NRF24L01' hardware module to function. See the following document for more infor-
mation:
http://www.deviationtx.com/wiki/#hardware_modifications
The SLT protocol supports up to 6 channels, and only supports auto-binding. The fixed ID can be used, but
does not prevent auto-binding during power-on.
Tartalomjegyzék
Deviation User Manual for Devo 6/8/12, Kiadás 5.1-dev
79