Advertisement
Available languages
Available languages
Safety Precautions
FCC Statement
1.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Any changes or modifications not expressly
approved by the grantee of this device
could void the user's authority to operate
the equipment.
Federal Communications Commission
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment
and receiver.
(3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
(4) Consult the dealer or an experienced radio/TV
technician for help.
2
RF Exposure Warning
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
instructions and transmitter operating conditions for
satisfying RF exposure compliance.
5GHz RF Device Statement
5.15~5.25MHz Band
• This device is operation in 5.15 – 5.25GHz frequency
range, then restricted in indoor use only,
• Outdoor operations in the 5150~5250MHz is prohibit.
Master Equipment:
The availability of some specific channels and/or
operational frequency bands are country dependent
and are firmware programmed at factory to match
the intended destination. The firmware setting is not
accessible by the end user.
This device is Master equipment, the transmission is
disabled in the 5600-5650MHz band.
Slave Equipment:
This device is slave equipment, the device is not radar
detection and not ad-hoc operation in the DFS band.
FCC RF Warning
This equipment must be installed and operated in
accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provided a
separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. End-users and
installers must be provide with antenna installation
instructions and transmitter operating conditions for
satisfying RF exposure compliance.
Advertisement
