Working With Grooving Tools - Hammer K3 winner User Manual

Panel Saw
K3 basic/K3 winner/K3 e-classic

9.5.12 Working with grooving tools

Warning! Risk of injury!
• Groove cuts may only be carried out with an
overhead saw guard! Do not, under any circumstances, use a saw blade guard (guard mounted onto splitter)!
• Do not pull back the fence guiding tracks (guide) of the rip fence!
• Removing the splitter.
• Adjust the cutting angle to 90°!
Attention! Risk of material damage!
!
Do not adjust the 90° angle when operating with grooving tooling!
Fig. 9-17: Working with grooving tools
X/2
Fig. 9-18: Working with grooving tools
Note: Tenoning hood and moulding guard „Sawboy"
see: Tools and Accessories catalogue
Fig. 9-19: Auxiliary fence
Operation
1. Take note of general procedures for authorized
2. Set the rip fence to the desired measurement.
3. Lock the sliding table into a centre position.
4. Set the cutting height to a maximum of half of that of
5. Always use the crosscut fence and the sliding table
6. When feeding the workpiece forward, press it hard
X
Fasten Sawboy by means of the screw onto the parallel
#
fence, in the case of a thin-walled fence by means of
said screw and the nut.
!
Operating and adjusting:
"
!
"
#
Gefaket!!
15 mm in Richtung dimetrie 1 verschoben
Schiebetisch, Grundbahn, Handrad Logo
working techniques.
the workpiece's thickness.
when making transverse grooves (see "Cutting to
length against the rip fence").
onto the sliding table.
Use an eccentric clamp if required. If an eccentric
clamp is used, shape the groove using the sliding
table.
Read individual operation instructions
Sawboy
Fence guide
Special-nut
63