Sony DSC-V1 Operating Instructions (English) Operating Instructions Manual page 27

Recording images with the
hologram AF
The hologram AF is fill light to focus more
easily on a subject in dark surroundings.
When not using this function, set
[Hologram AF] to [Off] in the SET UP
settings (page 115).
appears on the screen and the hologram
ON
AF emits red light when the shutter button
is pressed halfway until the focus is locked.
60 FINE
min
101
VGA
96
S AF
0EV
ON
F2.8
30
• If hologram AF light does not reach the subject
sufficiently or the subject has weak contrast,
focus will not be achieved. (An approximate
distance of 0.5 m to 2.8 m (19 3/4 inches to 110
1/4 inches) (W)/0.5 m to 2.5 m (19 3/4 inches
to 98 1/2 inches) (T) is recommended.)
• Focus is achieved as long as hologram AF light
reaches the subject, even if the light is slightly
off the center of the subject.
• When the focus preset distance is set (page 48),
the hologram AF does not function.
• If the hologram AF emitter is dirty, the
hologram AF light may be dimmed and focus
may not be achieved. In this case, wipe the
hologram AF emitter with a dry cloth.
• The hologram AF emitter emits very bright
light. Although there are no problems with
safety, directly looking into the hologram AF
emitter at close range is not recommended.
• Do not block the hologram AF emitter during
recording.
• The AF range finder frame is not displayed. AF
range finder frame indicator flashes and the
centrally-located subject has priority to focus
on.
• When you mount an adaptor ring (not supplied)
or telephoto end conversion lens (not supplied)
to the camera, the hologram AF light is
blocked. We recommend using hologram AF
together with the Sony HVL-F32X flash.
• The hologram AF does not function when SCN
is set to (Twilight mode) or
(Landscape mode).
About Hologram AF
"Hologram AF (Auto-Focus)" is an AF fill
light system that applies laser holograms to
enable you to shoot still images in dark
places. The Hologram AF system uses
gentler radiation than conventional high-
brightness LEDs or lamps, thus satisfying
Laser Class 1* specifications and
maintaining higher safety for human eyes.
* Hologram AF satisfies Class 1 (time base
30 000 seconds), specified in JIS (Japan), IEC
(EU), and FDA (US) industry standards.
Complying with these standards identifies the
laser product as safe, under the condition that a
human can look at the laser light either directly
or focused through a lens for 30 000 seconds.
27