Table of Contents
Advertisement
Step 4
Reinstall the AC input protective cover.
Step 5
Reinstall the rear cover for the DCPS.
(Optional) Installing Power Cables for Two AC Dual–Live Wire Inputs
Step 1
Install short-circuit copper bars. Connect AC input terminals 1-L1 and 2-L1 by using short-circuit
copper bar 1. Connect 1-L2 and 2-L2 by using short-circuit copper bar 2. Connect 3-L1 and 4-L1
by using short-circuit copper bar 3. Connect 3-L2 and 4-L2 by using short-circuit copper bar 4.
Then secure the four copper bars by using screws.
Step 2
Route AC input power cables through an appropriate cable hole on the rear of the subrack.
Step 3
Secure the AC input OT terminals to the corresponding short-circuit copper bars, as shown in
Figure 30.
Figure 30 – Installing Power Cables for two AC dual-live Wire Inputs
(1) Short-Circuit Copper Bar 1
(4) Short-Circuit Copper Bar 4
Step 4
Reinstall the AC input protective cover.
Step 5
Reinstall the rear cover for the DCPS.
(Optional) Installing Power Cables for One AC Dual–Live Wire Input
Install short-circuit copper bars. Connect AC input terminals 1-L1, 2-L1, 3-L1, and 4-L1 by using
Step 1
short-circuit copper bar 1. Connect AC input terminals 1-L2, 2-L2, 3-L2, and 4-L2 by using
short-circuit copper bar 2. Then, secure the copper bars by using screws.
Step 2
Route AC input cables through an appropriate cable hole on the rear of the subrack.
Step 3
Secure the AC input OT terminals to the corresponding short-circuit copper bars, as shown in
Figure 31.
20
(2) Short-Circuit Copper Bar 2
(3) Short-Circuit Copper Bar 3
Advertisement
Table of Contents
