Hudson Terraplane K 1934 Mechanical Procedure Manual page 109

SECTION 7
MECHANICAL PROCEDURE MANUAL
Page 15
Figure 724 shows the method of installation. The materials
required are included in Intake Manifold Drip Pipe Kit Number
152002.
Engine Mounting
The engine is supported on two rubber cushions at the ends of
the front engine support plate and a single rubber cushion under
the front of the transmission case.
The details of the front cushions are shown in Figure 725. The
nuts on the mounting bolts should be drawn down tight so that
the upper and lower plates are drawn against the bolt spacer.
In addition to the engine mountings there are also two rubber
bumpers held against the sides of the transmission case to steady
the rear of the engine and help absorb the engine torque. If
insufficient pressure is exerted by these bumpers against the
transmission case an excessive movement of the gear shift lever
will be evident, especially on rough roads.
Figure 725—Engine Mounting—Front
Figure 724—Intake Manifold Drip Valve Installation