NETGEAR PROSAFE XS716E User Manual page 96

8-Port or 16-Port 10-Gigabit/Multi-Gigabit Smart Managed Plus Switch
Factory default settings
You can return the switch to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the Factory Defaults button on the back panel of the switch
for at least four seconds. The switch resets and returns to the factory settings that are shown
in the following table.
Table 2. Factory default settings
Feature
Switch password
IP address
Subnet mask
DHCP mode
IGMP snooping
LAGs
VLANs
802.1p/DSCP-based QoS
Port-based QoS
Rate limiting
Broadcast filtering
Loop detection
Port speed
Flow control
Port mirroring
Supplemental Information
Setting
password
192.168.0.239 (if the switch is not connected to a network with a DHCP server)
255.255.255.0
Enabled
Enabled
None configured
Disabled. If enabled, by default, all ports are members of VLAN 1.
Disabled
Disabled
Disabled
Disabled
Disabled
Autonegotiation
Disabled
Disabled
96 User Manual