Safety - VERDEGRO TTMA Operation And Maintenance

6 Safety

1. Read these instructions carefully before using the "TTMA"
2. The TTMA should not be used without knowledge of the operating instructions and safety
precautions. Keep the operating instructions, always within easy reach of the machine, the
operator's manual should ALWAYS be at or near the machine.
3. The operator of the TTMA must be at least 18 years old and experienced in serving Trailer
truck mounted attenuators.
4. The owner/holder of the TTMA must ensure that all users are trained in the use of the
machine.
5. Be careful when the machine is used near live power lines.
6. Transport the TTMA only if it is properly secured to vehicle.
7. On the platform are no persons during storage and adjustment of the machine or in transit.
8. Make use at all times during the adverse influences of wind, rain, temperature, brine,
thunderstorms, snow, hail and ice.
9. Use the TTMA purely as Trailer truck mounted attenuator, and not as a transport trailer or
other device.
10. The wind load of the TTMA does not increase with additional signs or other objects that
could catch wind.
11. Inspect the entire machine for loose materials such as bird nests, twigs, leaves, but also
tools, bolts, nuts, etc. which may end up on the lanes during mobilization or transport.
12. Do not hoist the TTMA!
13. Before and during operation of the machine always look at / near the machine, no persons
are present, guiding also takes into account the rotation range of the machine!
14. For safe and trouble-free operation, the TTMA clean snow and ice held.
15. The TTMA regular inspection and maintenance of service - repair outsourcing to an expert in
this field service company.
16. The construction of the TTMA may not be altered without permission and the
manufacturer's instructions.
17. Inspect the TTMA every day before work or during use and pass through the machine.
18. Axles control all bolts / nuts: Before each use the principal axes, bolts and nuts.
19. Let the TTMA annual inspect by the manufacturer. The inspection must take place more
frequently if welding is done in supporting parts, or other special reasons exist for the device
Manual TTMA-100K Page 9 of 19