General Control Points Of Ttma; Repairs (By Manufacturer Or Official Distributor); Welding; Other Welding - VERDEGRO TTMA Operation And Maintenance

10 General control points of TTMA


Chassis:
o Corrosion
o Welds (no cracks visible)
o Permanent deformation

Elektrical system:
o Condition and suspension of cables
o Condition of connectors

Crash Cushion:
o Control of cracks and dents or cracks

11 Repairs (by manufacturer or official distributor)

11.1 Welding

If parts of the TTMA are repaired with welding, it should be noted in the report under "Remarks''

Welded points

Date of welding

Make sure when welding the manufacturer's instructions are followed

11.2 Other welding

If other repairs are made to supporting parts (example cylinders), make a note under "Remarks''

Maintenance points

Date

Contractor

Ensure that the repair to the manufacturer's instructions are followed
Manual TTMA-100K Page 14 of 19