Sony Cyber-shot DSC-F828 Operating Instructions Manual page 131

Message
Folder error
Cannot create more folders • The folder whose first three digits of the name is "999" exists on the recording medium. You cannot create any more
Cannot record
"Night shot"
"Night framing"
Manual focus is invalid
The flash is not open
640 (Fine) is not available
Busy
Buffer over
Read error
File error
Image size over
No file in this folder
Cannot divide
Invalid operation
Enable pritner to connect
Connect to device
Meaning/ Corrective Action
• The battery level is low or zero. Charge the battery pack (page 14). Depending on the conditions of use or the type
of battery pack, the indicator may flash even though there are still 5 to 10 minutes of remaining battery time left.
• A folder with the same first three digits number already exists on the recording medium. (For example: 123MSDCF
and 123ABCDE) Select other folders, or create a new folder.
folders.
• You attempted to select the folder that is available only for viewing with your camera. Select other folders (page 51).
• The amount of light is not sufficient, or camera shake may occur because a slower shutter speed is set. Use the flash,
or mount the camera on a tripod to steady the camera.
• An operation that is not valid while NIGHTSHOT is set was attempted.
• An operation that is not valid while NIGHTFRAMING is set is attempted.
• The FOCUS switch is set to MANUAL when the mode dial is set to
• Pop the flash up using the
• A recording medium that does not correspond to the [640 (Fine)] size movie is inserted (page 100).
• When using the Microdrive, the data writing process was not performed due to a drop in data transmission rate.
• When using the Microdrive, the data writing process was not performed due to a drop in data transmission rate. (This
message is indicated after the "Busy" message appeared.)
• The movies stored on the Microdrive cannot be played back due to an internal temperature problem or vibration.
• The file is corrupted.
• An error occurred while playing back the image.
• You are playing back an image of a size that cannot be played back on your camera.
• No images have been recorded in this folder.
• The movie is not long enough to be divided.
• The file is not a movie.
• You are playing back a file that was created on equipment other than your camera.
• [USB Connect] is set to [PictBridge], however the camera is connected to a non-PictBridge-compliant device.
Check the device.
• You tried to print images before the printer connection was established.
OPEN (FLASH) switch (page 69).
.
131