Siemens SIMATIC S5 Manual page 283

1.2 Installing the Adapter Casing in an S7-400 System
Introduction
To install an S5 module in an S7-400, you must first install the adapter casing
in the S7 rack. Select the address on the S5 module, and insert the module
into the adapter casing.
Installing the Use the following procedure to install the adapter casing in a rack:
adapter casing in
1. Verify that the wire jumpers at the rear of the adapter casing are closed
the rack
2. Set the CPU mode selector switch to STOP.
3. Set the standby switch on the power supply module to
4. Follow the instructions in the "S7-400/M7-400 Automation System" In-
Selecting the ad-
Select the address on the S5 module.
dress
IP244
C79000–B8576–C866–01
(state upon delivery). These jumpers are used for test purposes and must
always be closed. Fig. 1-1 shows the locations of these jumpers.
Bild 1-1 Location of the wire jumpers on the adapter casing
voltages).
stallation Manual for installing modules in a rack.
Adapter Casing (S5 Adapter)
(0 V output
7–5