Shape And Dimensions; Detailed Description Of Elements - Jofemar T15 User Manual

Shape and dimensions.

2.5.
As shown below. Figures in millimetres.

3. DETAILED DESCRIPTION OF ELEMENTS.

Standard 3.5 inch format.
There are four protruding pins on the sides for anchoring the unit in place.
The following components are located at the top of the unit:
•
The coin entry, which can be fitted with various parts to adapt it to the machine
coin slot.
•
The coin entry adapter consisting of two parts, one fixed and one moveable.
There are various adapters available in heights of 6, 10, 12, 16 and 18 mm.
•
The coin return lever, used to unblock jams and recover coins in the selector.
The following components are located at the bottom of the unit:
•
The accepted coin exit, where coin passage validation optical sensors are —
located on the left.
•
The rejected, unrecognised and disabled coin exit —located on the right.
On the front, there is the selector identification label with references, configuration
code, coins programmed for recognition, etc.
At the back there is a lid that protects the circuit card and provides access to three
connectors:
§
i Polarised 10-way connector: 2 rows of 5 contacts each, with a contact
pitch of 2.54 mm for connecting power supply and parallel interface to the
vending machine.
§
i Polarised 4-way connector: for connecting power supply and serial
interface to machines with cctalk protocol (optional).
MNP64ENV00 Date: 03-2007 Rev. 03 Page 6 of 16