Switch Programming; Tolerances; Programming Tolerances Using Switches - Jofemar T15 User Manual

5. SWITCH PROGRAMMING.

Tolerances.

5.1.
The selector is factory programmed to recognise the coins indicated on the unit's
label. Coin identification parameter margins can be modified individually by adding a
certain tolerance.
.
The following intervals can be set:
•
Zero tolerance (factory settings).
•
Minimum tolerance. (+ 10%)
•
Medium tolerance. (+20%)
•
Ample tolerance. (+35%)
Following is a description of the procedure to carry out such programming.
5.1.1.

Programming tolerances using switches.

è
The procedure is as follows:
1. Disconnect the selector (remove the connecting cable) or turn off the
machine that provides the selector with its power supply.
2. Move switches 1, 2, 3 and 4 to the ON position.
3. Apply the power supply (connect the connecting cable or turn the machine
on).
4. Move switch 1 to the OFF position.
5. Move switch 2 to the OFF position.
6. Move switch 3 to the OFF position.
7. You will now be in tolerance programming mode. Use switches 1 and 2 to
indicate the tolerance to be established for inserted and recognised coins:
1
OFF
ON
OFF
ON
OFF
•
Example 1: Program the 1 euro coin with medium tolerance.
8. To exit this programming option move all switches to the OFF position. The
selector should move the coin acceptance electromagnet twice to indicate
that you have exited programming.
MNP64ENV00
SWITCHES
2 3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF OFF OFF
Set SW.1 = OFF and SW.2 = ON.
o
Insert the 1 euro coin. When it is recognised, the tolerance
o
will be programmed.
If you do not wish to program tolerances in other coins, move
o
all switches to the OFF position, the selector will move the
acceptance electromagnet twice.
Date: 03-2007 Rev. 03
4
ON Zero tolerance.
ON Minimum tolerance.
ON Medium tolerance
ON Ample tolerance
End tolerance programming procedure
(acceptance electromagnet moves
twice).
TOLERANCES
Page 11 of 16