Test Run - Grizzly G1026 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
-26-
To test run machine:
1. Clear all setup tools away from machine.
2. Unlock and remove padlock installed by fac-
tory on FOR/REV switch using included key
(see Figure 30).
FOR/REV
Switch
Figure 30. Padlock must be removed from FOR/
REV switch before test run.
3.
Connect machine to power supply.
4.
Turn FOR/REV switch to forward (FOR) posi-
tion press ON button. Verify motor operation,
then press OFF button.
5. Turn FOR/REV switch to reverse (REV) posi-
tion and press ON button.
Motor should run smoothly and without vibra-
tion or unusual problems or noises in both
directions.
Correct any strange or unusual nois-
es before operating machine further (see
Troubleshooting, Page 44). Always discon-
nect machine from power when investigating
or correcting problems. If problems persist,
call Tech Support for help.
Congratulations! The Test Run is now complete.
Continue to Operations section.
Model G1026 (Mfd. Since 10/13)
Padlock
Key