Hold-Downs - Grizzly G1026 Owner's Manual

Hold-Downs

Hold-downs are used to hold the workpiece flat on
the table and snug against the fence as shown in
Figure 28.
To assemble the hold-downs:
1. Slide two hold-down brackets onto each of
the hold-down bars (one on the short arm,
one on the long arm), as shown in Figure 26.
Hold-Down
Brackets
Hold-Down
Figure 26. Brackets on hold-down bar.
2. Slide the long arm of the hold-down bars
through the holes in the cast iron fence brack-
ets, as shown in Figure 27.
Figure 27. Inserting hold-down bar into fence
bracket.
-24-
Bar
3. Partially screw the
into the hold-down brackets.
4. Slide each hold-down between a hold down
bracket and hold down bar, as shown in
FIgure 28.
Fence Bracket
Hold-Down
Bar
Hold-Downs
Figure 28. Using hold-downs on both sides.
5. Position the hold-downs according to the size
of your workpiece.
6. Tighten the set screws in the fence brackets
and the hold-down brackets to fix the position
of the hold-downs.
Note: Remove the hold-down assembly when
not in use.
Model G1026 (Mfd. Since 10/13)
⁄ "-18 x ⁄ " set screws
5 3
16 8
Hold-Down
Brackets