Table of Contents
Advertisement
DFW-SX900
DFW-X700
HOST ADAPTER CARD DFWA-400
Installing the Host Adapter Card
NOTE
: Before installing the host adapter card in the computer, be sure to install the setup disk
software provided. Otherwise the computer may freeze when started.
(1)
After starting the computer, insert the floppy disk provided into the floppy disk drive.
(2)
Open "My Computer" and select the floppy disk drive.
(3)
Open Readme.txt.
(4)
While reading Readme.txt, install the software.
(5)
After installing, eject the floppy disk, shut down Windows, and turn off the power of the computer.
(6)
Unplug the computer power cable from the wall outlet.
NOTE
: Make sure you unplug the computer power cable from the wall outlet. Installing the host
adapter card without unplugging the power cable may damage both the computer and the
card.
(7)
Open the computer case and remove the PCI bus slot cover.
(8)
Securely insert the host adapter card into the PCI bus slot and affix in place it with the screw.
NOTE
:
When you install the card, hold the top part of the card. Make sure that the PCI card edge is
parallel to the slot. Insert the card into the slot as straight in as possible.
You may need to apply some force when installing the card into the slot. Insert the card
until the card snaps into the slot.
If you are having difficulty inserting the card properly, remove it from the slot and try
again.
Some computers are not required a screw to affix the card in place.
(9)
Install the computer case.
44
- Quick Links:
- Connection
Hide quick links:
Advertisement
Table of Contents
