Sony DFW-SX900 Technical Manual page 37

COMMAND SENDING PROCEDURE UNTIL IMAGES ARE DISPLAYED
(3) Video transmission start command
When the following values are set for Status and Control registers for camera, the camera starts video transmission.
(Example: DFW-SX900, Video Format = 2, Video Mode = 0, Frame Rate = 7.5 fps, ISO Speed = 400M bps)
Address
F0F00600h
F0F00604h
F0F00608h
F0F0060Ch
F0F00614h
To stop the video, set the ISO Enable bit to 0.
Address
F0F00614H
(4) To set the trigger mode
Set Status and Control register for feature and set the trigger mode to ON.
Address
F0F00830h
As bit 0 is the Presence Inq bit, it cannot be written. Consequently, even if 02000000H is written for Data, the same
operations are performed.
Action Data
Write 40000000H
Write 00000000H
Write 40000000H
Write 12000000H
Write 80000000H
Action Data
Write 00000000H
Action Data
Write 82000000h
Frame Rate = 7.5 fps
Video Mode = 0
Video Format = 2
ISO ch = 1, Speed = 400M bps
ISO Enable ON
ISO Enable OFF
Trigger ON, mode 0
DFW-SX900
DFW-X700
35