Advertisement
The camera should be stored in a dry environment.
Do not turn on the camera and do not work with voltage in a humid environment.
Do not install cameras in a high humidity environment.
Do not install your camera on unstable or vibrating surfaces or brackets.
To remove the camera housing, use the included tools.
Do not use excessive force during the installation – you might damage the device.
If water gets into the camera, immediately disconnect it from the network and voltage supply.
Do not touch the camera during a thunderstorm.
Do not insert any objects in the camera.
Do not perform any other mechanical modifications than those listed in this guide or user
manual.
Do not replace / adjust components on the printed circuit board and wiring of connectors.
Do not use the camera with signs of damage or defects and/or with damaged cables.
Do not repair your camera yourself; in case of failure, contact the supplier of your camera.
Clean your camera with a cloth dampened with water - do not use chemicals, avoid abrasive
materials when cleaning.
Connect the camera using the UTP or STP cable category 5 or higher, with the RJ-45
connector.
The manufacturer is not liable for damages that were caused by unusual or unforeseeable
circumstances and the force majeure.
Do not throw the camera in the trash; after the end of life of the equipment it is necessary to
dispose of the product according to your applicable local law. Use the collection points for
WEEE in your area, ensuring the environmentally friendly disposal or return the product to a
vendor of electrical equipment.
The physical installation of the camera
The camera can be mounted both on horizontal and vertical surfaces (wall, suspended ceiling, roof
veneers etc.)
Select a location to install the camera, consider its location and direction to avoid the Sun in the view
of the camera
Cameras should be facing down to avoid direct Sun shining into the camera lens
The camera bracket has a cutout for cable outlet in case of a surface cabling – this cutout shall face
directly down
Use a template to drill the mounting holes
When installing the camera on a brick structure, drill the wall plug holes of ø 6 mm (indicated
o
"1" in the template) and insert the wall plugs into the holes
o
For the cable entry drill holes with the diameter of at least 20 mm (indicated "A" in the
template - not needed if the cabling is guided on the surface, e.g. in a bar)
The camera is connected with the bracket with the ball joint – on the camera bracket release the
matrix that ensures the camera alignment - see Fig. 2 2
Notice
info@cameracamera.gr | +30 210 6613866
w w w . c a m e r a c a m e r a . g r
www.facebook.com/cameracamera.gr
Advertisement
