Makita BJR181 Technical Information page 6

R
epair
[3] -3. Slider Section
DISASSEMBLING
1) After removing Shoe, then Insulation cover. (Fig. 13)
2) Remove the Blade clamp section. (See "[3] -1. Blade Clamp Section.)
Fig. 13
For smooth removal of Insulation cover,
apply soapy water into the slit between
Insulation cover and Gear housing cover
complete.
Important: Be careful not to wet
LED circuit with soapy water.
Gear housing
cover complete
Insulation cover
3) Remove Cover from LED circuit, then disconnect the
connector from the connector of Power supply unit.
(Fig. 14)
4) Remove LED circuit from Gear housing cover
complete by lifting up as illustrated in Fig. 15,
5) Remove Gear housing cover complete from Gear
housing complete by unscrewing four M5x25
Pan head screws. (Fig. 16)
Fig. 15
Gear housing
cover complete
LED circuit
Fig. 14
Fig. 16
Insulation cover
Slider, after removal of
the Blade clamp section
LED circuit
Gear housing
cover complete
Gear housing
complete
P 6 /14
Cover
Connector of
Power supply unit
Pan head screw
M5x25 (4pcs)