Makita BJR181 Technical Information page 13

W
iring diagram
1) Handle L
Be careful not to route Brush holder lead wire
(red) over this boss.
Fastening Connecting
Terminals to Switch
See bottom left of this page.
Be careful not to route
lead wire (blue) over this rib.
Fix the following lead wires
with these lead wire holders:
* Lead wire (blue) from
Power supply circuit
to Connector
* Lead wire (blue) from
Switch to Connector
Connecting Flag Connector
to Terminal
See bottom right of this page.
Terminal
With this lead wire holder, fix the following
lead wires from Power supply circuit:
*2 Lead wires (black, orange) to Switch
*Lead wire (blue) to Connector
Fastening Connecting Terminals
to Switch
Assemble the Connecting terminals
to Switch as illustrated below.
approx. 30 degrees
back of
switch
Connecting terminal
boss
Switch
rib
Lead wire holder
Fix Brush holder lead wire
Handle L
(black) with this lead wire holder.
Power supply circuit
Connector
Between this boss and the inside wall
of Handle, route the following lead wires
from Power supply circuit:
*2 Lead wires (black, orange) to Switch
*Lead wire (blue) to Connector
Connecting Flag Connector to Terminal
The flag connector has to be so connected that
the wire connecting portion is positioned on
the side of pole marks of Terminal.
Wire connecting portion
Flag connector
Terminal
P 13 /14
boss
Pole marks