Dmo Group Calls; Making A Dmo Group Call; Receiving A Dmo Group Call; Exiting Dmo - Motorola MTM800 Basic User's Manual

Group Call from the console operator (or dispatcher) to all users.
The MTM800 Enhanceds are configured to monitor a Broadcast
Call, but users cannot talk back.
The Broadcast Call pre-empts an on-going Group Call that has the
same (or lower) call priority.

DMO Group Calls

In DMO the MTM800 Enhanced can be used without your Service
Provider's infrastructure.
DMO allows communication with other terminals also operating in
DMO, which are on the same frequency and group as your MTM800
Enhanced.
In DMO it is only possible to place
Calls, Emergency Group Calls and Private Half-duplex Calls.
When you start a call, the members of the selected group who have
their units turned on will receive the Group Call.
In DMO the MTM800 Enhanced can communicate with the trunking
system (and vice-versa) if the Gateway option is enabled in the
MTM800 Enhanced.

Making a DMO Group Call

1. Enter Direct Mode by pressing Optns and selecting Direct
Mode.
2. Make sure that you have selected the required group. Press and
hold the PTT button.
3. Wait for the talk permit tone and then speak into the microphone.
Release the PTT button to listen.

Receiving a DMO Group Call

You can receive a DMO Group Call only when your MTM800
Enhanced is in DMO.
Unless it is engaged in a call, your MTM800 Enhanced will receive
the Group Call. To answer the call, press and hold PTT.
Your MTM800 Enhanced shows the group name and the caller's
private number or alias if previously stored in your contact list.

Exiting DMO

To exit DMO, press Optns and select Trunked Mode.
the following call types:
Group
25