Sony Cyber-shot DSC-P41 Operating Instructions Manual page 100

Symptom
You cannot format a
"Memory Stick."
You have formatted a
"Memory Stick" by
mistake.
PictBridge compliant printer
Symptom
The connection cannot be
established.
You cannot print images.
Printing is canceled.
100
Cause
• The write-protect switch on the "Memory Stick"
is set to the LOCK position.
• All the data on the "Memory Stick" are erased by
formatting. You cannot restore them.
Cause
• The printer is not compliant with the PictBridge
standard.
• The printer is not set for the connection with the
camera.
• [USB Connect] is not set to [PictBridge] on the
Setup screen.
• Depending on the circumstances, the connection
may not be established.
• The camera is not connected to the printer.
• The printer is not turned on.
• If you select [Exit] during printing, you may not
print again depending on your printer.
• Movies cannot be printed.
• Images modified with a computer or images shot
using other than this camera may not be able to
be printed.
• You disconnected the USB cable before the
(Not disconnect USB cable) mark
disappears.
Solution
p Set it to the recording position (page 112).
p We recommend that you set the "Memory Stick" write-protect
switch to the LOCK position to protect accidental erasure
(page 112).
Solution
p Consult with the printer manufacturer.
p Check that the printer is turned on and can connect with the
camera.
p Set it to [PictBridge] (page 110).
p Disconnect and connect the USB cable again. If an error
message is indicated on the printer, refer to the operating
instructions supplied with the printer.
p Check that the camera and the printer are properly connected
using the USB cable.
p Turn on the printer. For further information, refer to the
operating instructions supplied with it.
p Disconnect and connect the USB cable again. If you cannot
print still, disconnect the USB cable, turn off and on the printer,
then connect the USB cable again.
—
—
—