Dldp Authentication-Mode - H3C S7500 Series Command Manual

Command Manual – DLDP
H3C S7500 Series Ethernet Switches
Use the dldp enable command to enable DLDP globally on all optical ports of the
switch.
Use the dldp disable command to disable DLDP globally on all optical ports of the
switch.
In Ethernet port view:
Use the dldp enable command to enable DLDP on the current port.
Use the dldp disable command to disable DLDP on the current port.
The commands apply to both non-optical ports and optical ports.
By default, DLDP is disabled.
Note:
When you use the dldp enable/dldp disable commands in system view to
enable/disable DLDP globally on all optical ports of the switch, these commands are
only valid for the existing optical ports on the device, however, they are not valid for
those added subsequently.
Examples
# Enable DLDP globally on all optical ports of the switch.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] dldp enable
DLDP is enabled on all fiber ports.

1.1.3 dldp authentication-mode

Syntax
dldp authentication-mode { none | simple simple-password | md5 md5-password }
undo dldp authentication-mode
View
System view
Parameters
none: Performs no authentication with the peer port.
simple: Sets the authentication mode with the peer port to plain text.
Chapter 1 DLDP Configuration Commands
1-3