Programming The Remote Control - Sony WEGA KV-36XBR250, KV-32XBR250 Operating Instructions Manual

Operating a Cable Box or Satellite Receiver
Programming the Remote
Control
You can program the supplied remote
control to operate a cable box or satellite
receiver.
1
Press CODE SET.
2
Press SAT/CABLE (FUNCTION).
3
Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4
Press ENTER.
For more details on operating the
cable box or satellite receiver
Refer to the operating instructions that were
supplied with the equipment.
34
If the remote control doesn't work
First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips z
• If more than one code number is listed, try
entering them one by one until you come to the
correct code for your equipment.
• If you enter a new code number, the code number
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control.
In this case, use the equipment's supplied remote
control.
• Whenever you remove the batteries the code
numbers may revert to the factory setting.
Cable box code numbers
Manufacturer
Hamlin/Regal
222, 223, 224, 225, 226
Jerrold/G. I.
201, 202, 203, 204, 205,
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Satellite receiver code numbers
Manufacturer
801 (preset code for
Sony
General Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba
Code
206, 207, 208, 218
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213
Code
remote control)
802
805
804
803
802, 808
806, 807