Connecting To The Computer - Switrace I-PLUG pdf User Manual

Connecting to the computer
I-PLUG pdf will be detected by the computer as a USB disk drive and will be recognized
without any specific driver. There are, however, two possible situations.
• Device is not started: If you need to modify any of the parameters before starting the
I-PLUG pdf, plug the device in a USB port then press the START button, for the
computer to detect it.
• Device is working or stopped: As soon as the I-PLUG pdf is connected to the PC via
the USB port the computer will automatically detect the device.
The first time I-PLUG pdf is plugged in, it will trigger the creation of the PDF report (4 LEDs
on and fixed). DO NOT remove the I-PLUG pdf in this situation.
Once the device is ready, a new USB disk drive will appear on your PC allowing you to
download the PDF report.
IMPORTANT: keep in mind that, the more measurements the I-PLUG pdf took, the
more it will take for the PDF report to open. It could take as long as a 45 seconds if the
I-PLUG pdf is completely full. While the PDF report is downloading, LEDs will be lit
in a circular way.
IPST8 V.2 aug 2017 I-Plug pdf
I-PLUG pdf
Page 4 of 8