Understanding The Leds Indicators; 4 Blinking Leds; Blinking Green; Blinking Blue - Switrace I-PLUG pdf User Manual

Understanding the LEDs indicators
The LEDS will give you valuable information of the conditions of your shipment as indicated
in below table.
If you press START or STOP button briefly, while I-PLUG is running, LEDs will blink.
Here are the meanings:
Appearance of I-PLUG pdf
IPST8 V.2 aug 2017
Meaning

4 blinking LEDs

Ready state / Device has not been started.
NOTE: When the device is in a Ready state, only
the start button is active.
In a RUNNING state, when a button is pressed:

Blinking Green

This confirms that the device is already started.
NOTE: there is a fixed green LED during the first 2
minutes of recording.
Fixed Red
Device is in a STOP state.
In a STOP or RUNNING state, when a button is
pressed:

Blinking Blue

Low alarm has been triggered.
Fixed Blue
Ultra-low alarm has been triggered.
In a STOP or RUNNING state, when a button is
pressed:
Blinking Orange
High alarm has been triggered
Fixed Orange
Ultra-high alarm has been triggered.
SAMPLING state.
Orange LED automatically lights for 2 seconds
every time the device performed a temperature
record.
I-Plug pdf
I-PLUG pdf
Page 3 of 8