Sony KV-32HS500 Instructions: TV stand (primary manual) Operating Instructions Manual page 82

Channels
Problem
Cannot receive upper
channels (UHF) when
using an antenna
TV is fixed to one channel
Cannot receive any
channels when using
cable TV
Cannot receive or select
channels
General
Problem
How to reset TV to
factory settings
How to restore Video settings
to factory settings
How to restore Audio
settings to factory settings
Cannot cycle through the
other video equipment
connected to the TV
Cannot operate Menu
Lost password
TV makes "popping" sound
when turned on
LED on front panel is lit
Possible Remedies
❏
Cable
Change the option to
❏
Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 66).
❏
Auto Program
Use in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 66).
❏
Check your Channel Fix settings (see page 66).
❏
Auto Program
Use in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 66).
❏
Cable
Make sure the
❏
Use Auto Program in the Channel Menu to add receivable TV channels that
are not presently in TV memory (see page 66).
Possible Remedies
❏
Turn on the TV. While holding down the
control, press the POWER
back on again.) Release the
❏
Press the RESET button on the remote control while in the Video Menu (see
page 62).
❏
RESET
Press the button on the remote control while in the Audio Menu (see
page 64).
❏
Video Label
Be sure the
❏
If a menu option appears in gray, this indicates that the TV is in a state in
which the menu option is not available.
❏
In the password screen (see page 68), enter the following master password:
4357. The master password clears your previous password; it cannot be
used to temporarily unblock channels.
❏
This is a normal sound that results from the TV automatically degaussing
each time it is turned on.
❏
The STAND BY LED (see page 11) blinks when the TV is turned on, then
shuts off when the picture is displayed. If the LED blinks continuously, this
may indicate the TV needs service.
❏
The TIMER LED (see page 11) indicates that the timer is set (page 71).
When the timer is set, this LED will remain lit even when the TV is turned
off.
Off
(see page 66).
On
option is set to in the Channel Menu (see page 66).
RESET
button on the TV. (The TV will turn itself off, then
RESET
button.
Skip
option is not set to
button on the remote
(see page 73).
81