Toshiba RAV-DXC010 Installation Manual page 13

LC DX Interface
Procedure 2
Each time you push
numbers in the control group change cyclically.
Select the indoor unit you want to change settings for.
The fan of the selected unit runs and the louvers start
swinging. You can confirm the indoor unit for which
you want to change settings.
Procedure 3
Using "TEMP",
[ ].
Procedure 4
Using timer "TIME"
DATA [ ].
LC DX Interface Configuration
The circuit board of the ventilation kit is not preconfigured at delivery. Some parameters must be set using the DN code
menu.
Follow to the basic operation procedure (1 → 2 → 3 → 4 → 5 → 6).
DN
OUTDOOR MODEL (RAV-****-E)
CODE
11 CAPACITY CODE
DIRTY FILTER ALARM
01
(Disabled)
CENTRAL CONTROL ADDRESS
03
(Unset)
AUTO MODE
(Enabled)
0d
AUTO MODE
(Disabled)
AVAILABLE MODE
(Heat Pump)
0f
AVAILABLE MODE
(Cooling Only)
DEVICE TYPE
10
(Duct)
POWER ADDRESS
12
(Unset)
DEVICE ADDRESS
13
(Unset)
GROUP ADDRESS
14
(Unset)
AUTOMATIC RESTART
28
(Enabled)
* 0099 = address not assigned (system addresses are assigned during the automatic addressing by the system.
Central addresses can be assigned automatically with a central remote control or manually. Subsequent
modifications may lead to malfunction.)
** AUTO MODE Enabled / Disabled and HEAT PUMP / COOLING ONLY are automatically selected by the
connecting Outdoor unit.
button, indoor unit
buttons, specify CODE NO.
buttons, select SET
SM563AT SM803AT
SP564AT SP804AT
0009 0012
Procedure 5
Push button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
from procedure 2.
• To change other settings of the selected indoor unit,
repeat from procedure 3.
button to clear the settings.
Use
To make settings after
repeat from procedure 2.
Procedure 6
When settings have been completed, push
to determine the settings.
When button is pushed,
the display content disappears and the air conditioner
enters the normal stop mode.
(While is flashing, no operation of the remote
controller is accepted).
SM1103AT SM1403AT
SP1104AT(8) SP1404AT(8)
0015 0017
0000 (Default 0002)
0099* Default
0000** Default
0001**
0000** Default
0001**
0006 (Default 0000)
0099* Default
0099* Default
0099* Default
0001 (Default 0000 Disabled)
12
Installation Manual
button was pushed,
button
flashes and then
SM1603AT SM2244AT8
SP1604AT8 -
0018 0021
SM2804AT8
-
0023