P Board - Sony Trinitron KV-32S40 Service Manual

V. SIZE ADJUSTMENT ( VSIZ)
1. Input a cross-hatch signal.
2. Set to Service adjustment mode.
3. Select VSIZ with and
4.Adjust with and for the best vertical size.
5.Write into the memory by pressing
V. SIZE
/
V. POSITION ADJUSTMENT (VPOS)
1.Input a cross-hatch signal.
2.Set to Service adjustment Mode.
3.Select VPOS with and
4.Adjust with and for the best vertical center.
5.Write into the memory by pressing
V. POSITION
H. POSITION ADJUSTMENT (HPOS)
1. Input a cross-hatch signal.
2. Set the Service adjustment Mode.
3. Select HPOS with and
4. Adjust with and for the best horizontal center.
5. Write into the memory by pressing
H. POSITION
V LINEARITY (VLIN), V CORRECTION (VSCO), PIN AMP
(PAMP) AND PIN PHASE (PPHA) ADJUSTMENTS
1. Input a cross-hatch signal.
2. Set to Service adjustment Mode.
3. Select VLIN, VSCO, PAMP, and PPHA with
4. Adjust with and for the best picture.
5. Write the memory by Pressing
V LINEARITY(VLIN)
VS CORRECTION (VSCO)
**WARNING: Do NOT turn off the power or AC immediately after pressing
.
then
/
.
then
.
then
and .
then ** .
KV-32S40/32S45/34SL40/34SL40C/34SL40T/34SL45/35S40/35S45/37SL45/
32V40/32V65/34VL65/34VL65C/35V65/37VL65/37VL65C
PIN AMP (PAMP)
PIN PHASE (PPHA)
**.
V ANGLE (VANG), V BOW (VBOW), UPPER PIN (UPIN)
AND LOW PIN (LPIN) ADJUSTMENTS
1. Input a cross hatch signal.
2. Set to Service adjustment Mode.
3. Select VVANG, VBOW, UPIN, and LPIN with
4. Adjust with and
5. Write the memory by Pressing
V ANGLE (VANG)
**.
V BOW (VBOW)
UPPER PIN (UPIN)
**.
LOW PIN (LPIN)
P BOARD ADJUSTMENTS
PIP V. POSITION (PIPV), PIP H. POSITION (PIPH)
1. Input a color bar signal.
2. Set to service adjustment mode.
3. Select PHOP with
4. Adjust with and
corner P in P display position.
5. Adjust P in P put at lower right position.
6. Write the memory by Pressing
— 21 —
and
for the best picture.
then
and .
for the best balanced position at four
then
then . Wait at least 10 seconds.
.
** .
**.