3-5.White Balance Adjustments - Sony Trinitron KV-32S40 Service Manual

KV-32S40/32S45/34SL40/34SL40C/34SL40T/34SL45/35S40/35S45/37SL45/
32V40/32V65/34VL65/34VL65C/35V65/37VL65/37VL65C
( 2 ) Dynamic Convergence Adjustment
• Before starting, perform Horizontal and Vertical
Static Convergence Adjustment.
1. Slightly loosen deflection yoke screw.
2. Remove deflection yoke spacers.
3. Move the deflection yoke for best convergence as
shown below:
R
B G R B
G
R G B
B
R G B B G R
B
R G B R
G
B G R
R
4. Tighten the deflection yoke screw.
5. Install the deflection yoke spacers.
(3) Screen-corner Convergence
Affix a permalloy assembly corresponding to the
misconverged areas:
b a
a-d : screen-corner
misconvergence
c d
3-3. FOCUS
Adjust FOCUS control for best picture.
G
R
B G R R G B
G
B
b
a
c
d
3-4. SCREEN (G2)
1. Input dot pattern from the pattern generator.
2. Set the PICTURE and BRIGHT controls at normal.
3. Adjust S BRT, G CUT, B CUT in service mode with an
oscilloscope so that voltages on the red, green, and blue
cathodes are 170Vdc for 35"/37" and 180Vdc for 32"/34".
4. Observe the screen and adjust SCREEN (G2) VR
to obtain the faintly visible background of dot signal.
170 V dc/ 180 V dc
170Vdc
GND
3-5. WHITE BALANCE ADJUSTMENTS
NO. Disp. Item
16 GDRV Green Drive
17 BDRV Blue Drive
18 GCUT Green Cut-off
19 BCUT Blue Cut-off
23 SBRT Sub Bright
1. Input an entire white signal.
2. Set to Service adjustment Mode.
3. Set DCOL to "0"
4. Set the PICTURE and BRIGHT to minimum.
5. Adjust with SBRT if necessary.
Select GCUT and BCUT with 1 and 4 .
6.
Adjust with 3 and 6 for the best white balance.
7.
8. Set the PICTURE and BRIGHT to maximum.
Select GDRV and BDRV with 1 and 4 .
9.
10. Adjust with 3 and 6 for the best white balance.
11. Reset DCOL to "1".
12. Write into the memory by pressing
— 14 —
pedestal
Avg/32" Avg/35"
33 45
33 45
3 6
2 6
14 10
then **.