ActionTec Dual PC Modem R7000M User Manual page 6

Rear Panel
There are 5 ports (Power, 2, 1, Line, and Phone) and a Reset Switch on the rear
panel.
Power Adapter
(from Power Port
to Power Outlet)
Reset Switch
Depressing the reset switch for one or two seconds will reset the Modem. To
restore to factory default settings, depress and hold for at least 10 seconds.
Power Port
This port is used to connect the smaller end of the Power cord.
Port 2
This Ethernet port is used to connect an Ethernet cable between the Modem and
an additional computer.
Port 1
This Ethernet port is used to connect an Ethernet cable between the Modem
and the first computer connected.
Chapter 1 Introduction
UT ER
TO CO MP
RO UT ER
2
PO WE R
RE SE T
Ethernet Cable Ethernet Cable
(from Port 2 to (from Port 1 to
Second Computer) First Computer)
PH ON E
LIN E
1
Phone Cord
(from Line Port
to Phone Jack)
3
Phone Cord
(from Phone Port
to Telephone)