Table of Contents
Advertisement
Fig. 14
2. Mark the position of the two most suitable fixing slots for the wall plate and boiler lower
fixing holes. It is preferable to use the horizontal fixing slots.
3. Mark the position of the centre of the flue hole (rear exit). For side flue exit, mark as shown.
4. Note the shaded area on the template. Pipework may be routed upwards behind the boiler,
providing it does not conflict with the shaded area.
5. If required, mark the position of the gas and water pipes. Remove the template.
6. Cut the hole for the flue (minimum diameter 107mm).
Hide quick links:
Advertisement
Table of Contents
