Table of Contents
Advertisement
T_SEN1~2: Thermal Sensor Connectors
These connectors allow you to connect the thermistor cable and use it to monitor the
temperature of the detection point.
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
Important
Users will try extreme low temperature (must be higher than -124 degrees to prevent
y
Debug Code 00) overclocking at their own risks.
The overclocking results will vary according to the CPU version.
y
Please don't set to Enabled when the system is powered off or can' t be started.
y
46
Overview of Components
Sense
GND
Normal
(default)
Thermistor cable
Enabled
(Please enable this jumper
during BIOS POST.)
Advertisement
Table of Contents
