Connections - Sony Multiscan CPD-1404S Service Manual

1i •••
iII.Illi. __
rillliAnuiL~liIiiIliiildw~~~~Jfu~.iioJ~liii.,;~·~~ lL.:r .u.,nd·ti.w~u~.:m!t~h
.•
~.~U.;'~~Ll';":::~I~:';'l1hi \jh_:~i,,,,;),~i)
...... ,
II:
I'
1\:' ..
111
~j" ;~Y:;!.'l~
' ; U:,.J;
f:n:.' :\ ....
:.t .....
~,
,H";tt..a.:.:
I
CPD-1404S
[i]
AUTO SIZE switch
Depending on the microcomputer connected to the display, set this
switch to the appropriate position.
LOCK: For the IBM PS/2 microcomputer using the VGA mode.
When this switch is set to LOCK, the timing is automatically
adjusted to the VGA mode, and the H SIZE, H SHIFT, V SIZE
and V CENT controls will have no effect.
ADJ: For other microcomputers having analog RGB output.
When this switch is set to ADJ, adjust the display with the H SIZE,
H SHIFT, V SIZE and V CENT controls.
[ID
H SIZE (horizontal size) control
Turn this control to adjust the horizontal size of the display.
rn
H SHIFT (horizontal shift) control
Turn this control to adjust the centre of the display horizontally.
00
V SIZE (vertical size) control
Turn this control to adjust the vertical size of the display.
00
V CENT (vertical center) control
Turn this control to adjust the centre of the display vertically.
1-2. CONNECTIONS
Connect the power cord and the monitor cable.
Be sure to turn the power of the unit off before making the connection.
Rear of the CPD-1404S
"'-'=====
Microcomputer
AC power cord
(supplied)
t~!~i~~~
---c::iIld
toAC IN
to RGB OUT
Three-row O-sub 15 pin (male)
Colour monitor cable
1
Align the plug with the receptacle.
2
Plug in and tighten the
screws by hand.
To disconnect the plug, loosen the screws.
-5-
.• ~~~" -m~'!"~~~: :'1'~~ :·'··v~!-'
..
,
'1
,!~'
...
1- ~~"
.--:
.