Table of Contents
Advertisement
Enter successive numbers in the same way.
When the phone number of 16 digits or more
has been entered, the phone number appears in
two lines.
7
Turn Jog Dial to choose "[PGM]", and then
press Jog Dial.
You hear a long confirmation beep, and the
name and the number are stored.
The display goes off.
Notes
• Names cannot be entered using the dialing keys.
• Do not allow more than 20 seconds to elapse during the operation procedure.
Tips
• When you select "[GO BACK]", you can return to the previous set display by
pressing Jog Dial.
• If you have entered a wrong name or number in step 4 or 6, turn Jog Dial to
choose "[P]" then press Jog Dial or press (ERASE) to erase it. Then enter the
correct name or number.
• You may press (PROGRAM) instead of doing steps 5 and 7.
• Phone numbers can be entered using the dialing keys in step 6.
To store a number to be dialed via Private Branch Exchange
(PBX)
Before entering a phone number in step 6 on page 40, do as follows:
1
Enter the outside line access digit (e.g., 9).
2
Turn Jog Dial to choose "[P]" and then press Jog Dial, or
press (REDIAL/PAUSE).
Changing a stored name and/or phone number
1
Display the name you want to change by doing
steps 1 to 3 on page 39.
The cursor is at the right of the name.
2
Turn Jog Dial to choose "[P]", then press Jog
Dial to erase the characters, and enter the new
name.
If you want to change only the number, skip this
step.
SONY
1234567890123456
12_
0123456789*#
F P VIP PGM
ENTER NAME
SONY_
ABCDEFGHIJKLMNOP
QRSTUVWXYZ
SWITCH
NUMBER
continued
Telephone Features
41
US
Advertisement
Table of Contents
