Moog PRIZM Mini4 Series User's Manual And Troubleshooting Manual page 10

Moog Components Group
the remote unit.
Labeled '2.5V', located on the mid-right of the board. When 'ON' indicates the on-
D6 (Green)
board 2.5V converter is operational
Not labeled, located on the bottom center of the board. When 'ON' indicates that 5V
D7 (Green)
is available to the display LED ribbon header.
Labeled '5V', located on the lower right of the board. When 'ON' indicates +5V dc
D8 (Green)
is available to the board
Labeled '3.3V', located at bottom center of the board. When 'ON' indicates 3.3V is
D9 (Green)
available on the board.
Located on the left middle of the board, section labeled 'VID #1', provides an
D31 (Green)
indication of the presence of an input signal on video channel #1. When 'ON'
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Located on the left middle of the board, section labeled 'VID #2', provides an
D32 (Green)
indication of the presence of an input signal on video channel #2. When 'ON'
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Located on the left bottom of the board, section labeled 'VID #3', provides an
D35 (Green)
indication of the presence of an input signal on video channel #3. When 'ON'
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Located on the left bottom of the board, section labeled 'VID #4', provides an
D34 (Green)
indication of the presence of an input signal on video channel #4. When 'ON'
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Bottom of Board
LED Indication
Located on the upper right corner of the board, labeled RMT LINK LED. 'ON'
D10 (Green)
when the link is established with the remote M4 Video Output board and the data
stream is synchronized
D13 (Green) Located on the upper left corner of the board, RS-485 Diagnostics Interface. Blinks
ON/OFF with PMON II accesses to the board.
Located on the upper right corner of the board, labeled LOCAL LINK LED. 'ON'
D14 (Green)
when the link is established with the remote M4 Video Output board and the data
Mini4, Rev C
(201580-xxx And 201590-xxx)
Page 10 of 19
February 23, 2009