Basics; Making Calls - Sony SPP-A946 Operating Instuctions / Manual de instrucciones Operating Instructions Manual

Basics

Making calls

TALK/BATT
LOW lamp
VOL
switch
(HOLD)
(*TONE)
Additional tasks
To
Put a call on hold
Select a better channel
Adjust the handset
volume
Switch to tone dialing
temporarily
Switch to another call
("call waiting" service*)
* You need to subscribe to the service from your telephone company.
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
• When the TALK/BATT LOW lamp repeats a set of two flashes, the base
phone is in use.
• When you set the handset volume to H (high), the volume will be raised
considerably. Under normal circumstances, set the volume to M (middle).
16 US
Basics
(FLASH)
(CHANNEL)
(REDIAL/PAUSE)
Do this
Press (HOLD).
The TALK/BATT LOW lamp flashes slowly.
Press (TALK) to resume the conversation.
Press (CHANNEL).
Set the VOL switch to H (high), M (middle) or L
(low).
Press (*TONE) while using the telephone after
you're connected.
The line remains in tone dialing until disconnected.
Press (FLASH) to access the flash function.
Press (FLASH) again to return to the first caller.
1
Pick up the handset from the
base phone.
2
Press (TALK).
The TALK/BATT LOW lamp on
the handset and the IN USE
lamp on the base phone light up.
Then you'll hear a dial tone. If
you hear error beeps, move
closer to the base phone.
3
Dial the phone number.
4
When you're done talking, press
(OFF) or replace the handset on
the base phone.
The TALK/BATT LOW lamp on
the handset and the IN USE
lamp on the base phone go off.