Warnings And Notes; Standards / Directives; Commissioning (Electrical Connection); Maintenance - Drehmo i-matic Operating Manual

1 Warnings and notes

1.1 Standards / directives

DREHMO products are designed and manufactured in compliance with recognized standards and
directives. This is certified in a declaration of incorporation and a declaration of conformity.
The end user or the contractor must ensure that all requirements with respect to assembly,
electrical connection, and commissioning at the place of installation are met.
They include among others:
Applicable configuration directives for fieldbus applications.
•
National regulations, laws, and prescriptions.
•

1.2 Commissioning (Electrical connection)

During operation of electrical devices it is unavoidable that certain parts carry dangerous voltages.
All personnel working with this device must be familiar with the safety and warning instructions in
this manual and observe the instructions given. Safety instructions and warning signs on the
device must be observed to avoid personal injury or property damage.

1.3 Maintenance

Maintenance directives have to be carefully attended. Otherwise a safe operation of the actuator
or control unit can't be assured.
1.4 Warnings and notes
Read these instructions carefully before installation and commissioning. Failure to follow them
may lead to personal injury or to material damage.
The following signs draw special attention to safety-relevant procedures in these operation
instructions:
This symbol signifies „additional information".
Failure to observe may lead to damage occurring.
This symbol signifies „attention".
Failure to observe may result in damage and personal injury.
This symbol signifies „warning!"
Failure to observe may result in damage and severe personal injury.
DREHMO – i-matic Modbus loop redundant board
Complementary operating manual
page 5 of 32