Activadose tDCS Device User Manual
"LOW BATT
REJECT" and during
stimulation "BAT"
indicator lights.
Specifications
Electrical Shock
Environmental Conditions
Ingress of Water
Flammability
Mode of operation
Dimensions
Weight
Cleaning
Disposal
Controls
Dose Range
Maximum Voltage
Maximum Current
Current Ramp Up
Current Ramp Down
Battery
Display
•
Battery voltage is too low for
stimulation to continue.
•
Unit will not allow
stimulation to be restarted.
•
Unit ramps down current
before preset dose is
complete.
Type BF Applied Part.
Transport and store 50°F to 131°F (10°C to 55°C).
Operate 41°F to 104°F (5°C to 40°C). Humidity less
than 90%. Atmospheric pressure from sea level to
9,842 feet (3,000m)
Not protected against ingress of water
Do not use around flammable gases, liquids or
materials.
Continuous.
6.1" x 3.5" x 1.9" (15.5 x 8.9 x 4.8cm)
.4 lbs. (.18kg)
Clean the case and lead clip wires as needed with an
alcohol moistened cloth. Do not immerse in fluids.
Dispose of according to local, state and federal
regulations. Remove battery before disposal.
Two (dose and current)
0 to 80 mA-min.
80V DC (or 29V DC)
4.0 mA (or 2.0 mA)
Automatic (0 to 4.0 mA)Built-in option for manual
override
Automatic at end of tDCS session; paused or turned off
by depressing knob. Built-in option for manual override
Use only 9V DC Alkaline. Ensure battery door is in
place before starting tDCS session. Remove battery
from unit when not in use.
Dose, Time Remaining, and Current(displayed
simultaneously with interactive set-up)
10
Caputron
•
Replace battery.