Connection Check List - Alpine R-A75M Owner's Manual

CONNECTION CHECK LIST

Please check your head unit for the conditions
listed below:
Remote Turn-On Lead
a. The head unit does not have a remote turn-on
or power antenna lead.
b. The head unit's power antenna lead is activated
only when the radio is on (turns off in the tape
or CD Mode).
c. The head unit's power antenna lead is logic level
output (+) 5 V, negative trigger (grounding
type), or cannot sustain (+) 12 V when
connected to other equipment in addition to
the vehicle's power antenna.
If any of the above conditions exist, the remote
turn-on lead of your R-A75M/R-A60F must be
connected to a switched power source (ignition)
in the vehicle. Be sure to use a 3 A fuse as close
as possible to this ignition tap. Using this
connection method, the R-A75M/R-A60F will
turn on and stay on as long as the ignition
switch is on.
If this is objectionable, a SPST (Single Pole,
Single Throw) switch, in addition to the 3 A fuse
mentioned above, may be installed in-line on
the R-A75M/R-A60F turn-on lead. This switch will
then be used to turn on (and off ) the R-A75M/R-
A60F. Therefore, the switch should be mounted
so that is accessible by the driver. Make sure the
switch is turned off when the vehicle is not
running. Otherwise, the amplifier will remain on
and drain the battery.
Blue/White
Power Antenna
Remote Turn-On Lead
To other Alpine component's Remote Turn-On
Leads
SPST Switch (optional)
Fuse (3 A)
As close as possible to the vehicle's ignition tap
Ignition Source
Amplifier
7
-EN