Siemens SIMATIC Field PG M4 Getting Started page 16

Installing and connecting
4.3 Connecting the device to power
For the USA and Canada:
For the United States and Canada, a CSA or UL-listed power cord must be used.
The connector must be compliant with NEMA 1-15P.
120 V/240 V supply voltage
A flexible cable with UL approval and CSA marking must be used. In addition, the cable must
exhibit the following properties:
● 3-wire SPT-2 or SVT,
● At least 18 AWG conductor cross-section
● Max. length of 4.5 m
● Connector 15 A, min. 125 V
Connecting
Steps for connecting the device to mains
1
2
3
4
5
6
7
8
16
Turn the PG over so that it is
lying on the table with its display
unit closed.
①
Release the battery cover
②
on the bottom of the device
and open it.
Insert the battery.
Close the cover and turn the
device over again.
Insert the supplied power supply
cable into the external power
supply.
Insert the low-voltage connector
①
into the connection on the
device.
Plug the external power supply
into a socket with a grounded
protective conductor.
Turn the PG over again.
SIMATIC Field PG M4
Getting Started, 10/2012, A5E31347325-AA