Fisher & Paykel OM25BLSB1 Installation Manual/User Manual page 7

Built-in microwave oven
Hide thumbs Also See for OM25BLSB1:
Table of Contents

Advertisement

Consult an electrician or a Fisher & Paykel trained and supported service technician
if the grounding instructions are not completely understood, or if you are not sure
whether the appliance is properly grounded. If it is necessary to use an extension
cord, use only a 3-wire extension cord.
If using a long cord set or extension cord, ensure that the marked electrical rating
of the cord is greater than the electrical rating of the appliance.
The long cord should be arranged so that it will not drape over the counter top or
tabletop where it can be pulled on by children or tripped over unintentionally.
Ensure the power supply cord is undamaged and does not run under the oven or
over any hot or sharp surface.
The socket must be readily accessible after installation so that it can be easily
unplugged in an emergency.
Installation
This appliance is intended to be used for normal personal, family or
household purposes.
This is a built-in microwave oven intended to be installed in a cavity only.
Make sure that all the packing materials are removed from the inside of the door.
DO NOT use the oven outdoors.
Check the oven for any damage, such as misaligned or bent door, damaged door seals
and sealing surface, broken or loose door hinges and latches and dents inside the
cavity or on the door. If there is any damage, do not operate the oven and contact
a Fisher & Paykel trained and supported service technician.
This microwave oven must be placed on a flat, stable surface to hold its weight and
the heaviest food likely to be cooked in the oven.
Do not place the oven where heat, moisture or high humidity are generated or near
combustible materials.
Electrical
Never unplug your appliance by pulling on the power cord. Always grip the plug firmly
and pull straight out from the outlet.
Do not plug in any other appliance at the same power point as your appliance or use
extension cords or double adapters or ungrounded (two prong) adapters.
If the power supply cord is damaged, it must only be replaced by a Fisher & Paykel
trained and supported service technician.
All electrical repairs must be carried out by a Fisher & Paykel trained and supported
service technician or qualified electrician in order to avoid a hazard.
Ensure that the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.
It is hazardous for anyone other than a Fisher & Paykel trained and supported
service technician or qualified electrician to carry out any service or repair operation
that involves the removal of a cover which gives protection against exposure to
microwave energy.
SAFETY AND WARNINGS
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Om25blsx1Om25blcx1

Table of Contents