Table of Contents
Advertisement
On Mounting on a Rack
Leave 1U space empty above and below the monitor to
ensure adequate air circulation or install a fan to
maintain the monitor's performance.
If you have any questions about this unit, contact your
authorized Sony dealer.
On Fan Error
The fan for cooling the unit is built in. When the "FAN
ERROR" message is displayed, turn off the power and
contact an authorized Sony dealer.
About this manual
The instructions in this manual are for the following
four models:
• LMD-1410
• LMD-1420
• LMD-2010
• LMD-2020
The illustration of LMD-1420 is used for the
explanations.
Any differences in specifications are clearly indicated
in the text.
10
Features
Features
The LMD-1410 and the LMD-1420 are a 14-type, the
LMD-2010 and the LMD-2020 are a 20-type LCD
monitor.
High brightness LCD panel
Because of the monitor's high brightness, high contrast,
high speed response, and wide viewing angle
technology, it can be used under various lighting
conditions.
Rack mount monitors
The LMD-1410/1420 can be installed in a standard 19-
inch rack using an optional rack mounting bracket MB-
526 and the LMD-2010/2020 can be installed using MB-
527. This is essential when space is paramount in
crowded OB vehicles.
Monitor stand with tilt function
As the stand with tilt function is euipped for the monitor,
you can use it easily on the desk top. When you mount
the monitor to the rack, remove the stand.
Lightweight, thin design
The lightweight, thin design reduces the load for an OB
vehicle and the space needed for installation.
3-color tally lamp (LMD-1420/2020)
The tally lamp lights in red, green or amber to monitor
each input picture and check the on-air mode.
Two color system available
The monitor can display NTSC and PAL signals by
connecting this unit. The appropriate color system is
selected automatically.
Blue only mode (LMD-1420/2020)
In the blue only mode, an apparent monochrome display
is obtained with all three of the R/G/B cathodes driven
with a blue signal. This facilitates color saturation and
phase adjustments and observation of VCR noise.
Analog RGB/component input connectors
Analog RGB or component signals from video
equipment can be input through these connectors.
Y/C input connectors
The video signal, split into the luminance signal (Y) and
the chrominance signal (C), can be input through this
connector.
SDI optional input (LMD-1420/2020)
SDI signals can be available when input adaptor BKM-
320D (optional) is attached.
Hide quick links:
Advertisement
Table of Contents
