Table of Contents
Advertisement
VEHICLE CONTROLS
One-Touch Turn Signal
Use this quick and convenient method to
signal a lane change.
Lightly push the turn signal lever up or
down for an automatic three-blink
sequence.
For a continuous signal, push the lever up
or down until it locks into place.
40 |
Auto High Beam
The front sensor camera detects the light sources ahead of the vehicle such as
the lights of a preceding or oncoming vehicle, or street lights. When you are
driving at night, the system automatically switches the headlights between
low beam and high beam depending on the situation.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the
windshield, be careful not to apply windshield cleanser to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair, consult a dealer.
If you see the message "Some Driver Assist Systems Cannot Operate: Clean
Front Windshield", park your vehicle in a safe place. Wipe away debris
blocking the windshield, then start driving again. If the message remains even
after driving for a while with the clean windshield, have your vehicle checked
by a dealer.
If you see a message that the camera is too hot, use the climate control
system to cool the interior. Defroster mode will direct airflow toward the
camera.
n
Automatically switching between high beam and low beam
When auto high beam is active, the headlights switch between high beam
and low beam based on the following conditions.
If you find the timing of beam changes inconvenient for driving, change the
beams manually.
Switching to high beam
All of the following conditions must be met before the high beams turn on.
VEHICLE CONTROLS
| 41
Hide quick links:
Advertisement
Table of Contents
