Installing Batteries; Low Battery Indicator - CARNES Comfort Control User Manual

Table Top and Wall Mounts
The Remote Thermostat is shipped with a foot for table
top use and a sub-base for wall mounting.
Important!
The sub-base snaps are not designed for repeatedly
removing and installing the Remote Thermostat on the
sub-base.
Attach the foot to the back
of the Remote Thermostat
by snapping it into place.
Table Foot

Installing Batteries

Installing Batteries for the First Time
Slide the battery cover down and install two
1.
AA batteries being sure to observe the
polarity.
The Remote Thermostat will power up in Remote
Control Mode.
Observe the word Link in the display indicating
the Remote Thermostat is ready to Link to a
wireless actuator.
2. Set the correct time and day.
Replacing Batteries
After replacing the batteries, set the correct time and of day. The
remote thermostat retains its link to the actuator. This is indicated
by the word Linked in the display.
Or, install the sub-base on an
interior wall about 5 feet above
the floor and out of sunlight
using two screws as shown.
The Remote Thermostat snaps
onto the sub-base.
%
%
Heat
Link
Mo
PM
Menu
Remote
Calibrating the Temp Sensor
Press AIRFLOW or INDOOR TEMPERATURE (shown in grey).
1.
Remote Control Mode
%
Linked
Tu
AM
Menu
Remote
Use the UP / DOWN keys to set the
2.
Indoor Temperature to the calibrated
value.
Press ENTER to save the change and
3.
return to normal operation.

Low Battery Indicator

When the battery voltage drops down, the LCD will display
"Lo" indicating that the batteries need to be changed. Low
battery voltage may reduce range. Batteries should be
replaced with AA alkaline. Refer to Installing Batteries in
manual.
Remote Control Mode
%
Linked
Tu
AM
Menu
Remote
5 6
Thermostat Mode
o
F
Indoors
Link ed
Set To
Tu
Schedule
AM
Day
Thermostat
Menu
o
F
Indoors
Next
Menu
Enter
Thermostat Mode
o
F
Indoors
Link ed
Set To
Tu
Schedule
AM
Day
Thermostat
Menu