GALAXIS SHOWTECHNIK PYROTEC G-Flame User Manual page 7

7
4. For the usage of the device in places of public assembly an
approval by the authorities that are responsible for the fire
prevention is necessary.
5. If flame effects are being used no easily inflammable materials
should be present in general. In places of public assembly this kind
of material is normally forbidden by the legislator. By the usage of
flame retardant spray these materials can be rendered hardly
inflammable.
6. Smoking or open fire is strictly prohibited within the safety
zone! Keep off any other sources of ignition.
7. Depending on the type, size and quantity of the effects that are
being used and depending on the local conditions, allocate the
necessary fire prevention and first aid measurements.
8. In all cases respect and follow any national and technical
regulations as well as the operation manuals respective to the
devices in use.
9. Ensure that the devices are standing securely and that the
position or tilt can not vary during the application. Depending on
the circumstances it can be necessary to mount the devices e.g. by
using screws. Please mind the chapter in this user manual which is
dealing with the mounting of the devices on truss elements.
10. Ensure that the device is not covered by anything and that the
fuel can be easily exhausted through the nozzle. Furthermore ensure
that no foreign objects like e.g. confetti or streamers enter the
burning chamber.
11. Arm (switch on) the devices as shortly as possible before the
effect and disarm (switch off) them immediately after the effect.
Optionally this can be achieved either by using the emergency off
input or the main switch or the hazard zones or the DMX safety
channel. The hazard zones can be turned off and on either by a
wireless command or by using serial data cables. As soon as the
devices are armed or respectively ready to fire they must be
constantly supervised by the responsible operator.
12. Ensure that no heat sources like strong spotlights are pointed
towards the devices or the gas cartridges or the gas bottles.
13. Make sure that non authorized persons can not gain access to the
effect and control devices.
14. The safety boundary distances required by the manufacturer and
authorities are to be respected. Secure the area so that non
authorized persons cannot gain access to the same.
15. The operation manuals and safety instructions of the
manufacturer of the effect and control devices must be observed at
all times. If in doubt these must be discussed with the relevant
safety organisations.